ADVANTECH MIC-8101

® MIC-8101 6U CompactPCI 10/100 Ethernet Switch Features  Full wire-speed on all ports  VLAN IEEE 802.1Q - ID tagging, 802.1p priority  802.3 ad link aggregation  Packet filtering and port security  Multicast and broadcast storm control  GVRP/GMRP VLAN and multicast registration  DHCP/BootP packet forwarding  RIPv1, RIPv2 routing, DVMRP, PIM (dense mode)  Low port latency  Hot-swap with LED indication for RSS  Designed for interoperability within third-party PICMG 2.16-compliant platforms Introduction The MIC-8101 board is a high performance managed switch that supports both Layer 2 and Layer 3 features. This high-performance managed Layer 3 switch with 22 10/100 Mbps ® Ethernet ports and 2 Gigabit Ethernet ports enables fast connection speeds and flexibility in a 6U CompactPCI board. The in-chassis switch minimizes external wiring and needs no extra rack height, improving density and reliability. The MIC-8101 routes and switches at full wire-speed with its non-blocking architecture, along with its sophisticated multicast protocols to limit unnecessary traffic. The console is accessed through a RS-232 serial cable to configure the following management functionalities: SNMP, Telnet CLI and RMON. ® It provides an in-chassis switch fabric that can operate in a redundant configuration. The PICMG 2.16 CompactPCI Packet Switching Backplane Specification blends the benefits of CompactPCI with the broad acceptance of Ethernet. Specifications Ethernet Interface 10Base-T/100Base-TX/1000Base-T 10/100 RJ-45 x2 Connector 10/100/1000 RJ-45 x2 Front I/O Panel Serial 1 (RS-232) Typical +3.3 V +5 V +12 V Power Consumption 6 A 4 A 20 mA 22 10/100 Fast Ethernet ports to the mid-plane connectors 2 10/100 Fast Ethernet ports (RJ-45) on the front panel 2 10/100/1000Base-T Ethernet ports (RJ-45) on the front panel Auto-negotiation function for 10 M/100 M speed, duplex (full and half) and flow-control Layer 2 Switching Function Auto polarity and auto MDI/MDI-X 8000 entry MAC address forwarding table IEEE 802.3x-compliant flow control support in full-duplex 802.1D Spanning Tree/802.1Q tagged VLAN/802.1p priority GARP VLAN registration protocol Hardware-based Layer 3 IP switching 2000 entry IP address forwarding table RIP-I/II routing protocol Electrical Layer 3 Switching Function IPv4/IGMPv2/DVMRPv3/802.1D frame/DHCP/BootP relay PIM dense mode/IP multi-netting/IP fragmentation Path MTU discovery Wire speed IP forwarding rate RS-232 port for out-of-band management and system diagnosis Telnet remote control console SNMPv1 agent RMON 4 groups-statistics, history, alarm, event Management Capability Web-based IP filtering on management interface DHCP client Password-enabled MIC-8101 Specifications Cont. Operating Non-Operating Temperature 0 ~ 50 °C (32 ~ 122 °F) -25 ~ 55 °C (-7 ~ 131 °F) Environment Humidity - 95 % @ 40 °C (non-condensing) Vibration (5 ~ 500 Hz) 1.0 Grms 2.0 G Dimensions (W x D) 233.35 x 160 mm (9.2" x 6.3"), 1-slot width Physical Characteristics Connector J1 ~ J5 Weight 0.7 Kg (1.54 lb) PICMG 2.16 R1.0 CompactPCI Packet Switching Backplane Specification Compliance PICMG 2.9 R1.0 System Management Specification CE - Regulatory Safety UL/cUL 60950, EN/IEC 60950, CB report Scheme Emission FCC Part 15 (subpart B), EN 55022, CISPR 22, Bellcore GR-1089T Ordering Information Part Number Description MIC-8101-A Single-slot 6U CompactPCI 10/100 Ethernet Switch ® Note: MIC-8101 is licensed from Intel ZT-8101, please refer to Intel web site for more detailed technical information RS-232 serial port for out-of-band management and system diagnosis (Management Serial Port) LEDs for Ethernet port link, speed, and activity Two 10/100 Mbps LAN ports Two Gigabit Ethernet ports LED for board status LED for hot-swap status J1~J5 Online Download www.advantech.com/products