PCM-4823 486 SBC with VGA/LCD/Ethernet PCM-4823/L 486 SBC with VGA/LCD/Ethernet Startup Manual Enhanced IDE hard disk drive interface: Supports up Packing List Packing List Packing List Packing List Packing List to two IDE (VL-bus) hard disks. BIOS auto-detect and PIO Mode 3 transfer protocol Before you begin installing your card, please make sure Serial ports: One serial RS-232 port, one serial that the following materials have been shipped: RS-232/422/485 port. Two 16550 serial UARTs • 1 PCM-4823/L all-in-one single board computer Parallel port: One parallel port, supports SPP/EPP/ ECP mode1 startup manual Infrared port: Shared with COM2. Transfer rate up to1 CD-ROM or disk for utilities, drivers, and manual 115 kbps (in PDF format) Keyboard/mouse connector: Mini-DIN connector1 3.5" IDE flat cable supports a standard PC/AT keyboard and PS/2 mouse 1 keyboard/mouse cable Power management: Supports power saving modes 1 secondary serial port cable (RS-232/422/485) including Normal/Standby/Suspend modes. APM 1.1 compliant 1 parallel cable ® • Supports M-Systems' DiskOnChip 2000 Flash disk 1 floppy cable up to 144 MB If any of these items are missing or damaged, contact your Watchdog timer: 1.6 second interval distributor or sales representative immediately. Local-bus Flat Panel/VGA Interface (PCM-4823) Note: For detailed information on the PCM-4823/L, please refer to the enclosed CD-ROM or disk Chipset: C&T 65550 (in PDF format). Display memory: 1 MB DRAM Display type: Supports CRT and flat panel (EL, LCD and gas plasma flat panel) displays. Can simultaneously Specifications Specifications Specifications Specifications Specifications display CRT and flat panel CRT display mode: Non-interlaced CRT monitors, resolutions up to 1280 x 1024 @ 16 colors Standard SBC Functions Panel display modes: Supports resolutions up toCPU: Embedded AMD DX5-133 (5 x 86-133) processor 1024 x 768 BIOS: AWARD 128 KB Flash memory Chipset: VIA VT82C496G Ethernet Interface System memory: One 72-pin SIMM socket, acceptsChipset: RTL 8019AS 4/8/16/32 MB and supports FPM or EDO DRAM from 1 I/O address switchless setting to 32 MB Software compatible with NE1000 and NE2000 Built-in boot ROM Mechanical and Environmental For more information on this and other Advantech products please visit our website at:Dimensions (L x W): 145 mm x 102 mm (5.9" x 4.2") Power supply voltage: +5 V (4.75 V ~ 5.25 V) http://www.advantech.com http://www.advantech.com/epc Power requirements: +5 V @ 2 A (typical) For technical support and service please visit our supportOperating temperature: 0 ~ 60° C (32 ~ 140° F) website at: Weight: 0.65 kg (weight of total package) http://support.advantech.com This manual is for the PCM-4823/L. Part No. 2006482302 1st edition Printed in Taiwan Aug. 1999 PCM-4823/L Startup Manual 1 Jumper Settings Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors ® J2: DOC 2000 address setting The PCM-4823/L has a number of jumpers that allow you to Pins Address configure your system to suit your application. 1-2 3-4 5-6 closed closed closed C800 ~ C9FF The table below lists the function of each of the board's closed closed open CC00 ~ CDFF jumpers and connectors: *closed open closed D000 ~ D1FF closed open open D400 ~ D5FF Jumpers open closed closed D800 ~ D9FF Label Function open closed open DC00 ~ DDFF ® open open closed E000 ~ E1FF J2 DOC 2000 address setting J3 LCD power selector open open open OFF J4 Clear CMOS J6 COM2 selector J3: LCD power setting J8 Watchdog timer action Closed pins Voltage 1-2 3.3 V Connectors *2-3 5 V Label Function CN1 Power connector (-5 V, -12 V) J4: Clear CMOS CN2 Floppy disk connector Closed pins Result CN3 PC/104 connector 1-2 Clear CMOS CN4 Parallel port connector *2-3 3 V Battery on CN5 PC/104 connector CN6 Flat panel connector J6: COM2 selector CN7 Hard disk connector Closed pins Result CN8 IR connector (infrared) *1-2 RS-232 CN9 COM2 connector 3-4 RS-422 CN10 Ethernet connector 5-6 RS-485 CN11 Power connector (+5 V, +12 V) CN12 COM1 connector CN13 PS/2 keyboard and PS/2 mouse J8: Watchdog timer action CN14 CRT display connector Closed pins Result J5 Reset switch 1-2 IRQ11 J7 CPU fan connector *2-3 System reset * default setting 2 PCM-4823/L Startup Manual Locating Jumpers Mechanical Drawing Mechanical Drawing Mechanical Drawing Mechanical Drawing Mechanical Drawing J2 J3 J8 J6 J4 Locating Connectors CN4 CN7 CN6 CN11 HDD CN1 LED J5 CN2 CN14 CN8 CN13 SIMM1 CN10 NET LED CN9 CN12 J7 CN5 CN3 PCM-4823/L Startup Manual 3